wand-control.com

Hi, I just got my wonderful wand last week and I'd be perfectly happy with it if there wasn't just that one issue...

I've got a satellite receiver (Topfield...I think 5500 something.) And the original control has a forward and backward cue button.
When I press a button only for a short time the playback will switch from 1x to 2x, then 4x, 6x and then back to 1x speed.
That works fine with the wand...but
If I press the original button and hold it for, say half a second, a bar appears with the hole record and a cursor where I can set the cursor by holding the button or at least get steps from 1 minute per one button-push.
Is there a possibility to get into that bar with my wand? I think it would have to send the signal just a little longer ... or do you think the original remote sends another signal if I hold the button ?

Kind regards
Benny

The current version of the wand unfortunately does not support continous signals.
If you're lucky it is a different code that the original remote sends after the long keypress.

Hopefully you don't need that functionality that often. Most of the basic commands should work fine (at least it was the case for me).

HTH

Michael